Fujitsu MB9B100A Series, User Manual

Page: 32 / 56

AN706-00044-1v0-E
1
Figure 5-15: operation: open the select signal window
Click Select Signal button (1 in
Figure 5-15
) to select the signal for waveform display,
and the Signal Selection Window in
Figure 5-16
is displayed.
The following example shows the waveform display of U, V, and W phase current.
Select Compressor tab in Signal Selection Window (1 in
Figure 5-16
). Select
Current signal or All signals in Signal type (2 in
Figure 5-16
). Check the Selection
checkboxes of U-current, V-current, and W-current (3 in
Figure 5-16
). At this time,
make sure that the signal is selected (4 in
Figure 5-16
). After that, click OK button (5
in
Figure 5-16
). The Graphic Window of
Figure 5-17
is displayed and the waveform
can be observed in real time.
31