Fujitsu MB2198-503-E, Operation Manual

Page: 7 / 14

4
4. PROCEDURE FOR CONNECTING TO THE USER SYSTEM
Before using the header board, mount the supplied NQPACK on the user system.
The header board is connected to the adapter board using the 2 flat cables (standard or long) included
with the adapter (which is sold separately). See the operation manual of the adapter for details on
how to connect the flat cables.
■
Connecting
1. To connect the header board to the user system, align pin 1 indicated by the index mark (
▲
) on
the NQPACK mounted on the user system with the index mark (
▲
) on the header board and then
insert the header board (see Figure 3).
The YQPACK pins are thin and easy to bend. Check that the YQPACK pins are not bent before
inserting the YQPACK into the NQPACK.
2. Insert each of the screws for securing the header board through a washer and into each of the four
holes in the header board. To tighten the screws, use the special screwdriver supplied with the
NQPACK to evenly tighten the diagonally opposite screws in turn (see Figure 4).
Be careful to avoid overtightening the screws as this may cause a bad connection.
Figure 3 Index position
CN1
B60 A60
CN
3
B
B1 A1
FL
AT C
N
B
CN2
A
B60 A60
B1 A1
FL
AT C
N
A
NQPACK
index (
▲
)
Header board
index (
▲
)