Fujitsu Lifebook C1320, User Manual

Page: 29 / 125

18
ADDING MEMORY
MODULE
Where to install memory
module
Your notebook has an expansion RAM module
slot (slot 2) to add in one additional memory
module.
The memory capacity of the notebook can be
increased to a maximum of 2 GB (1024 MB x 2).
Preparing necessary items
• Philips screwdriver
Use a screwdriver of appropriate size to
remove the screws on the cover. Failure to
do so may damage the head of the screws.
Memory Module Configuration Table.
The table below shows combinations of
memory that can be installed on your
notebook.
Total capacity Slot 1 Slot 2
256 MB 256 MB
512 MB 256 MB 256 MB
768 MB 256 MB 512 MB
1 GB 512 MB 512 MB
2 GB 1024 MB 1024 MB
Before installing any memory module,
remember to power off the notebook
and disconnect the AC adapter from it.
Keep small objects, such as a cover,
caps and screws, out of the reach of
babies and children. These small
objects may suffocate a baby or child if
they are swallowed accidentally. Should
such an accident happen, consult a
doctor immediately.
Cer tain components around the
memory slots are very hot when the
notebook is powered on for a long period
of time.
To avoid possible burns, do not install
or remove memory module immediately
after turning off the notebook but wait
for a while until its internal components
cool down.
Memory
compartment
cover
The installation of any combination of memory
other than the combinations shown below can
impair the functioning of your notebook.
This LifeBook is capable of operating in dual
channel memory mode. To realize the full
performance benefits of dual channel operations,
we recommend you upgrade memory module
using Fujitsu memory module such that the two
memory modules in the memory slots are of the
same capacity and specification.
Installing memory module
To install memory, perform these steps.
LB_Cotton 03 (17-21) 9/11/05, 12:10 PM 18
Downloaded from www.Manualslib.com manuals search engine