Fujitsu IRF-1D series, User Manual

Page: 93 / 182

Chapter 3 - Setup and Installation
Multi-Port Mirrored Single Host-Dual Connection Configuration
81
Multi-Port Mirrored Single Host-Dual Connection Configuration
1 Set the jumper (JP4) on the Disk I/O card to configure the bus speed mode.
Loosen the two captive fastener screws for the Disk I/O card and pull it from
the enclosure using the fastener screws. Locate the jumper JP4 and position it
for the desired speed setting, (installed on one pin only for 2 Gb mode and
on both pins for 1 Gb mode).
Disk I/O Card
2 Re-install the Disk I/O card. Repeat step 1 for the second Disk I/O card.
3 Locate the switches on the SES Controller card and set them as indicated in
the illustration on the following page. Refer to “SES Controller Card Switch
Setting Overview” on page 52 for the other available settings.
Disk I/O Card Jumper Settings for the imageRAID IRF-2Sxx-xx/IRF-2Dxx-xx Enclosures
JUMPER INSTALLED BOTH PINS INSTALLED ONE PIN (OFFSET)
JP1 imageRAID Controllers Only * Non-imageRAID Controllers
JP2 imageRAID Controllers Only * Non-imageRAID Controllers
JP3 Split Bus Mode
JBOD Enclosures Only * Single Bus Mode
RAID Enclosures and Daisy
Chain JBOD Enclosures
JP4 1 Gb/sec Bus Speed Mode * 2 Gb/sec Bus Speed Mode
* indicates default setting
P1
DISK I/O
P2
OK
OK
2G
Fibre Disk IO
LRC
P/N 08-9-96318001
A/W Re
v-1
INST
ALL JUMPE
RS 1 & 2
FOR HARD
WARE
FAILURE DETECT
ADD JUMPER FOR
1G OPERA
TION
JP1
JP4
JP3
JP2
ADD JUMPER FOR
SPLIT B
US MODE
FC-AL Loop Port
Loop Status LED
2 Gb/1 Gb Mode LED
Jumper JP3 must be offset
or installed on one pin only.
This enables Single Bus mode.
Jumper JP4 must be set
to one pin only for 2Gb mode.
Position it on both pins for
1Gb mode.
Jumpers JP1 and JP2
must be installed on
both pins .
imageRAID.book Page 81 Tuesday, September 23, 2003 4:08 PM