Copyright © Fujitsu General America, Inc.
29
30
28
b
28
c
Test Run
Test Run Setting
(4) Press and hold the
CHECK
button
again
for approximately 5
seconds. The Check
operation will start.
(5) Check operation
will stop automatically.
If you MUST stop the
system, press the
MODE/EXIT button.
connected units.
Operating in Check
Run Mode
Check operation will stop automatically when done.
You cannot execute the stop operation using the
remote control.
When you’ve completed this step, power
needs to be reset.
When an error occurs, consult the
installation manual for complete
instructions following error display.
•
During test run, the outdoor unit and the connected
indoor units will start operating. Room temperature
control along with the remote controller commands will
be ignored during test run.
•
Test run set with the outdoor unit doesn't stop
automatically. Be sure to stop the Test Run to place
the system in normal operation cooling/heating.
•
Operation mode cannot be changed during the test run.
To change the operation mode, please stop test run first.
Perform after successful Check
Operation (28a) above.
Test run is not
possible during
an error code
condition.
Refer to the installation
manual for all error codes
and repair instructions.
•
Press
Mode/Exit
button
•
Press
Select
button until
F3 appears
•
Press
Enter
•
Select “00”
•
Press
Enter
Press the “MODE/EXIT” button.
Press the “SELECT” button.
Press the “ENTER” button.
(When [F4] to [F9] are displayed, continue to press
the SELECT button until [F3] is displayed.)
MODE/EXIT
SELECT
ENTER
OPERATION HAS FINISHED
NORMALLY WITHOUT ERROR.
Copyright © Fujitsu General America, Inc.
