(Continued from the front page)
Step5 Exit the Operation
Step4 Access a Serial Device
NC14013-0927RS-03
＜
Inquiry about our products
＞
FUJITSU COMPONENT LIMITED Marketing Group
TEL: 81-3-5449-7006
E-mail: [email protected] URL: http://www.fcl.fujitsu.com/en/
8. Confirm there is a check in "Enable all ports". To change the
default pin out when a Cisco device is connected to the
selected port, click the "Enable Cisco RJ45 Pin-Out" checkbox.
To reconfigure the connections settings to match the device
connected to the selected port, make the needed changes in
the Communication Settings area of the screen. And then click.
4. The ”Password:” prompt is displayed. Enter the current login
user password (in this case: admin).
Log out the OBWI after finishing the operation.
Perform an operation on a connected serial device.
1. Click [LOGOUT] in top right of the OBWI.
1. Select “Access” from left menu in Expert mode, the content
area displays the name of this device and list of each port.
The basic operating procedure has completed.
5. The following message appears, and serial device operations
are enabled.
NOTES
Installing Java Runtime Environment (JRE).
You have to install Java Runtime Environment (JRE) of Sun
Microsystems in a remote terminal to let this document Step4
display the serial viewer screen of mention. If not yet, download
Java software in the following web site and install it.
http://www.java.com/en/
Or, JRE is stored in CD-ROM, please
use it. In addition, by the setting of the browser, it is necessary
for JRE to become effective.
・
A confirmation method of the JRE availability (IE 7)
Click [Tools] menu
→
[Internet Options]
→
[Advanced] tab.
Make sure that Java Sun [Use JRE 1.x.x._xx for <applet>
(requires restart)] is checked. (x is version No.)
2. Select ”Serial Viewer” from the ”Action” column
These settings can be changed again later.
9. Save is executed, and the screen below appears. Click [finish].
6. Click [Disconnect] in bottom of the Serial Viewer window or [x]
in top right of the Serial Viewer window to finish the operation.
3. Start up a Java applet, the following Serial Viewer window is
displayed. When the warning dialog appears, click "Run".
10. The First Time Configuration has completed, and Expert mode
screen appears.
* When a popup block becomes effective in a browser (e.g.
Internet Explorer), Serial Viewer window is not displayed. You
have to configure a browser to admit popup window.
For software setup or details on operations, refer to
the Installer/User Guide in the CD-ROM provided
with the device.
