Fujitsu FUTRO A300, Operating Manual

Page: 10 / 29

Important notes
Important notes
Importantnotes Notes
In this chapter you will fi nd information regarding safety which it is essential to
take note of when working with your device.
Safety notes
Safetynotes Note
Please follow the safety notes provided in the "Safety/Regulations" manual
as well as the safety notes given below.
When installing and operating the device, please observe the notes on ambient conditions
in
"Technical speci fi cation ", Page 23 and the instructions in "Getting started", Page 9 .
Replace the lithium battery on the mainboard exactly in accordance with the
instructions in the
"Replacing the lithium battery", Page 22 chapter.
Caution, components in the system can get very hot.
The activities described in these instructions must always be
performed with the greatest care.
Repairs to the device must only be carried out by quali fi ed technicians. Incorrect
repairs could put the user at great risk (electric shock, hazardous energy emissions,
risk of
fi re) or cause serious damage to the equipment.
Power cable and mains adapter:
The supplied power cable conforms to the requirements of the country in
which you purchased your device. Make sure that the power cable is approved
for use in the country in which you intend to use it.
The mains adapter’s power cable should only be connected to a mains
socket if the device is connected.
Do not use the mains adapter for other devices.
Use only the mains adapter which is intended for use with the device,
see chapter
"Technical speci fi cation ", Page 23 .
Make sure that the rated current of the mains adapter is not higher than that of
the power system to which you connect the mains adapter.
ON/OFF switches do not disconnect the device from the mains voltage. To completely
disconnect the mains voltage, remove the power plug from the power socket.
Transporting the device
Device, Transportation Retransportation
Transport all parts separately in their original packaging or in a packaging which
protects them from knocks and jolts, to the new site.
Do not unpack them until all transportation manoeuvres are completed.
If the device is brought from a cold environment into the room where it will be used,
condensation may occur. Before operating the device, wait until it is absolutely dry
and has reached approximately the same temperature as the installation site.
6 Fujitsu Technology Solutions