Chapter 2 How to Load Documents
45
Area Not to Be Perforated
An error may occur when there are punched holes in the area
shaded in light blue in the figure below.
Fig. 1
Conditions for Multifeed Detection
Multifeed is an error where two or more sheets are fed through
the ADF at once. When a different document length is
detected, this detected result is also called a multifeed.
Multifeed detection is performed by either checking the
overlapping of documents, length of the documents, or the
combination of both. The following conditions are required for
an accurate detection.
Detection by Overlapping
Paper weight: 27 to 413 g/m
2
(7.2 to 110.6 lb)
Do not punch holes within 35 mm (1.38 in.) over the center of the
document. See
Do not attach other documents within 35 mm (1.38 in.) over the
center of the document. See
.
Detection by Length
Load documents of the same length in the ADF paper chute (feeder).
Variance in document lengths: 1% or less
Do not punch holes within 35 mm (1.38 in.) over the center of the
document. See
Detection by Overlapping and Length
Load documents of the same length in the ADF paper chute (feeder).
Paper weight: 27 to 413 g/m
2
(7.2 to 110.6 lb)
Variance in document lengths: 1% or less
Do not punch holes within 35 mm (1.38 in.) over the center of the
document. See
Do not attach other documents within 35 mm (1.38 in.) over the
center of the document. See
.
ATTENTION
The above condition applies when the document is set to the center of
the pick roller width.
HINT
If there are any holes in the 35 mm-wide central column, you can move
the document to the left or right to avoid an error.
( Unit: mm)
Top
Reference point
Front side
Feed
direction
Bottom
35
Center
