Fujitsu fi-7300NX, Operator'S Manual

Page: 107 / 321

Feeding Documents Manually
Documents can also be loaded manually one sheet at a time in the ADF paper chute (feeder).
The scanner waits for the next document to be loaded within a specified time. Scanning will continue as long as
another document is loaded within the set time, and stops if no document is loaded.
By using this method, you can perform scanning as you check the documents one by one.
Manual feeding is effective in the following cases:
● To scan documents as you check the contents of each sheet
● To scan documents that are fed overlapped or jammed when the documents are loaded together in a batch
● To continue scanning documents such as magazines or newspaper clippings that cannot be loaded together, one
at a time
●
To scan a document folded in half, an envelope, or a multi-layered transfer paper one at a time
1
Configure the settings for the scanner.
● When scanning more than one document manually
a
In the [Manual Feeding] screen on the touch screen, set [Continuous Feed Mode] to on and
specify [Timeout seconds].
The [Manual Feeding] screen can be displayed in the following procedure:
→ [Scanner Settings] → [Paper Source/Feeding] → [Manual Feeding]
When using the Software Operation Panel, refer to Waiting Time in Manual Feeding [Manual
Feeding] (page 301) .
●
When scanning a document folded in half, an envelope, or a multi-layered transfer paper manually
a
Slide the feed mode switch to the left to switch the feed mode to Manual Single Mode.
b
In the [Manual Feeding] screen on the touch screen, specify [Timeout seconds].
The [Continuous Feed Mode] setting is ignored, and the [Timeout seconds] setting is enabled.
The [Manual Feeding] screen can be displayed in the following procedure:
→ [Scanner Settings] → [Paper Source/Feeding] → [Manual Feeding]
When using the Software Operation Panel, refer to Waiting Time in Manual Feeding [Manual
Feeding] (page 301) .
ATTENTION
For details about the paper weights of the documents that can be scanned, refer to Documents for
Scanning (page 81) .
When a document folded in half is scanned, the document may be fed skewed if the folded part is too
thick.
2
Load a document in the ADF paper chute (feeder).
Load the document face-down in the ADF paper chute (feeder).
Various Ways to Scan
107