Chapter 6 Replacing Consumables
94
The following table shows the consumables used for the
scanner.
Consumables must be replaced periodically. It is
recommended that you keep a stock of new consumables and
replace them before it reaches the end of the consumable life.
The scanner records the number of sheets scanned after
replacing the consumables (for pick roller, separator roller,
brake roller), which allows you to check the status on each
consumable.
To check the status on the usage of the consumables, refer to
"8.3 Settings Related to Sheet Counters" (page 145)
.
Note that the suggested replacement cycles are guidelines for
using A4 (80 g/m
2
[20 lb]) wood-free or wood containing
papers, as these cycles vary depending on the type of papers
scanned and how often the scanner is used and cleaned.
To purchase the consumables, contact your FUJITSU scanner
dealer or an authorized FUJITSU scanner service provider.
Please note that some parts (other than the consumables)
need to be replaced by a service engineer, depending on the
type of documents scanned and how often the scanner is
used. For instance, Maintenance Parts (e.g. assist roller) need
to be replaced by a service engineer. For more information,
contact your FUJITSU scanner dealer or an authorized
FUJITSU scanner service provider.
6.1 Consumables and Replacement Cycles
Name
Part No.
Suggested replacement
cycle
PICK ROLLER
PA03575-K011
600,000 sheets or one year
SEPARATOR ROLLER
PA03575-K012
600,000 sheets or one year
BRAKE ROLLER
PA03575-K013
600,000 sheets or one year
Only use the specified consumables.
