background image

Fujitsu SCSI (650) VRS

 Scanner Installation Procedures

 

Windows ME\2000\XP 

 

If you are installing the following models by means of the Kofax 650 Adrenaline SCSI 
controller with/without a GSA-2 then use this document. 

 
M4097D-VRS  

M4099D-VRS  

Fi-4860C-VRS 

Fi-4990C 

Fi-5650C-VRS Fi-5750C-VRS   

 

 

 

 

If you do not have a 650 controller and are not going to use VRS then use the SCSI 
scanner installation guide.  If you are going to use the optional video interface then use 
the video scanner installation guide.  If you have an 850S/1700S controller and a GSA-1 
interface then you must use the SCSI (GSA-1) VRS scanner installation guide.  

 
 
Hardware requirements. 

 
You will need a PC system that meets both Fujitsu’s and Kofax’s recommended 
specifications, a Kofax 650 Adrenaline controller and six foot (maximum) Wide SCSI 68-
pin cable.  For recommended PC system specifications and SCSI controllers please 
reference the 

Scanner Hardware Reference

 page.  You may also need your Operating 

System Disk. 
 
 

Step A: Installing the VRS drivers. 
 

First boot your PC and install the Kofax VRS driver that shipped with the scanner. 
 

Special note: 

When installing the VRS driver and any other software that contains 

Kofax’s Image Controls pay close attention to the individual runtimes.

  It is strongly 

recommended that you install the oldest/lower runtime application first. 
 

 

Step B:  Installing the Adrenaline 650 Adrenaline controller 

 

1.  Shut down your PC and remove the case cover. 
2.  Locate a free PCI slot and remove the back plate if necessary. 
3.  Install the SCSI controller in an open PCI slot.  Make sure that the card is 

seated completely in the slot and secured in the frame. 

 

Warning!

  Failure to secure the SCSI controller in the PC can result in damage 

to the SCSI card, scanner, and/or your system. 
 

4. 

Boot your PC without the scanner attached and check for errors.  Make sure 
that the SCSI controller is listed as a 650 Adrenaline.  If no errors proceed to 
the next step.

 

 

 
Step C:  Unlocking the shipping lock.

 

 
If your model scanner does not have a flatbed then proceed to Step D.  
 

Rev052206A 

 

Page 1 of 3 

Reviews: