8
3.2 Microfilter Installation Procedures
Installing microfilters should not require any new inside
wiring. Existing wired RJ-11 telephone jacks are all that is
required to complete this installation. See
Figure 3-1
for an
installation diagram.
1. Start in the location where you want to install your
DSL modem. Look for the existing phone outlet (RJ-11
faceplate), and remove the existing RJ-11 cord from the
wall.
2. Connect the provided two-outlet modular adapter
device into the RJ-11 telephone jack.
3. Connect the provided DSL modem RJ-11 line cord, part
number FC9660CB26, into one side of the two-outlet
modular adapter.
4. Connect the other end into the RJ-11 LINE slot, located
on the back of DSL modem.
5. Connect one of the provided microfilters into the
remaining empty two-outlet modular adapter slot.
Figure 3-1: Typical Splitterless Installation
m1227.fh8_4
RJ-11
Phone
Jack
Microfilter
Telephone
DSL Modem
FC9660RA12
2-Outlet
Modular
Adapter
LINE
PHONE
Line
RJ-11 Line Cord
FC9660CB26
POWER
MODEM
DAT
A
DATA
DATA
LINE
LINE
