Chapter 3 Configuration Settings and Display
3.3 RAID Group Management > set eco-mode
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED
P2X0-1030-09ENZ0
129
set eco-mode
This command enables or disables the ECO mode. The ECO mode is a power saving function that will turn off
the disk motor when the disks are not being accessed. The ECO function cannot be used unless the ECO mode
is enabled.
■
Syntax
■
Parameter
■
Example(s)
set eco-mode [-mode {enable | disable}]
-mode
Optional. This parameter specifies if the ECO mode is enabled. If omitted, the existing setting
is not changed.
enable
ECO mode is enabled.
disable
ECO mode is disabled.
The following example enables the ECO mode.
CLI> set eco-mode -mode enable
The following example disables the ECO mode:
CLI> set eco-mode -mode disable
Summary of Contents for Eternus DX410 S2
Page 2: ...This page is intentionally left blank ...
Page 756: ......