Fujitsu ETERNUS CS800 S6, User Manual

Page: 255 / 561

10.5 Replication Configuration
If the target system is at ETERNUS CS800 2.1 software or higher, the Source IP field is
not required. If the target system is at ETERNUS CS800 2.0.1 software or below, then
you must enter the IP address by which the target system recognizes the source
system. The default value is
0.0.0.0 .
The Source IP field does not accept fully qualified domain names. You must
enter a valid IP address. Make sure this IP address is configured in the
allowable sources list on the target ETERNUS CS800.
When configuring segmented network interfaces, if the source ETERNUS
CS800 replication, data, and management interfaces are on the same
subnet, you must add a host route on the source ETERNUS CS800 to make
sure the replication interface is correctly selected when replicating data to
the target ETERNUS CS800 (see
"Understanding Interface Routing" on page
304 ).
5. Click Apply .
The new target is not automatically added to existing replication schedules. You
must add or edit scheduled events to schedule replication to the new target (see
"Scheduler" on page 262 ).
Editing a Replication Target
Edit a replication target to change encryption options or the source IP address.
To edit a replication target:
1. Under Target System , select the target and click Pause to pause replication.
2. Select the target again and click Edit .
The Edit Target Host window displays (see "Edit Target Host" on page 255 ).
If you are editing a target, you cannot change the Target Hostname or IP .
Figure 178: Edit Target Host
3. In the Encryption drop-down box, select the type of encryption to use when sending
replication data to the target system ( None , 128-bit , or 256-bit ).
ETERNUS CS800 255