Fujitsu ETERNUS CS800 S5, User Manual

Page: 175 / 634

Configuration Wizards Replication Wizard
U41840-J-Z125-7-76
161
Step 1: About
1. Read the information about the wizard (see Figure 104 ).
2. Click Next to continue.
I
At any time while using the wizard, you can click Previous to return to the previous
step.
Figure 104: Replication Wizard
Step 2: System
1. If data on this ETERNUS CS800 will be replicated to another system, enter the following
information under Target System (see Figure 105 ). You can specify up to two targets:
I
If two targets are already specified, you must delete a target before adding
another. First click
Pause to pause replication to the target, and then click
Delete to remove the target.
a) In the Target Hostname or IP Address box, enter the hostname or IP address of
the system that will receive the replicated data.
I
When entering IP addresses, never use an address that is in a reserved IP
address range. To see a list of reserved IP address ranges, click the quick
tip icon
[?] located near the IP address field.
I
To use hostname format, you must specify at least one DNS IP address on
the
Network page (see "Network" on page 286 ).
b) (Optional) Select the Encrypt data before replication check box selected to
enable encryption when sending replication data to the target system. Or clear the
Encrypt data before replication check box to disable encryption when sending