Getting started
Setting up the device
Videoworkstation
Ergonomic
Device,
When setting up your device, please read the recommendations and
safety notes in the "Safety/regulations" manual.
We recommend that you place your device on a surface with good anti-slip qualities.
In view of the multitude of different
fi
nishes and varnishes used on furniture, it is
possible that the rubber feet will mark the surface they stand on.
Depending on the location of your device, bothersome vibrations and noises may
occur. To prevent this, a distance of at least 10 mm / 0.39 in should be maintained
from other devices on casing sides without ventilation surfaces.
In order to avoid overheating, do not cover the ventilation areas
on the monitor or the device.
For ventilation areas, a minimum distance of 200 mm / 7.87 in from
the device must be maintained.
Do not stack several devices on top of each other.
Do not expose the device to extreme ambient conditions (see
, "Ambient conditions"). Protect the device against dust, humidity and heat.
Operating position
You can use the device in a vertical or horizontal operating position.
With the aid of suitable feet, it is possible to use the device in a vertical operating position
(see
"Vertical operating position with feet (optional)", Page 13
).
Vertical operating position with feet (optional)
Use the optional feet when you wish to use the device in the vertical operating position.
The set-up direction is compulsory: The captions "FUJITSU" and "ESPRIMO"
must be facing upwards so that suf
fi
cient ventilation is ensured.
You must remove the feet again to be able to open the device.
Verticaloperatingposition
Operatingposition,vertical
Base feet
Sidecover
Proceed as follows to operate the device in the vertical operating position with the feet:
►
If necessary, disconnect the cables connected to the device.
Fujitsu
13
