4
Fig. 1 Indoor Unit
1
Operating Control Panel (Fig. 2)
2
MANUAL AUTO button
3
Remote Control Signal Receiver
4
Indicator Lamps (Fig. 3)
5
OPERATION Indicator Lamp
(green ...... COOL, DRY, FAN)
(red .......... *HEAT)
6
TIMER Indicator Lamp (yellow)
7
SWING Indicator Lamp (orange)
(VERTICAL SWING)
8
SWING Indicator Lamp (orange)
(HORIZONTAL SWING)
●
If the TIMER indicator lamp flashes when
the timer is operating, it indicates that a
fault has occurred with the timer setting
(See page 15 Auto Restart).
9
Intake Filter (Fig. 4)
;
UP/DOWN Air Direction Flaps
A
RIGHT/LEFT Air Direction Louvers
(behind UP/DOWN Air Direction Flaps)
B
Drain Hose
C
Air Cleaning Filter (optional)
Fig. 5 Outdoor Unit
D
Intake Port
E
Outlet Port
F
Pipe Unit
Fig. 6 Remote Control Unit
G
SLEEP button
H
MASTER CONTROL button
I
SET TEMP./SET TIME buttons (
)
J
Signal Transmitter
K
TIMER button
L
FAN CONTROL button
M
START/STOP button
N
AIR FLOW DIRECTION
VERTICAL SET button
O
AIR FLOW DIRECTION
VERTICAL SWING button
P
AIR FLOW DIRECTION
HORIZONTAL SET button
Q
AIR FLOW DIRECTION
HORIZONTAL SWING button
Rear side (Fig. 7)
R
TIME ADJUST button
S
ACL button
(located inside battery compartment)
T
TEST RUN button
●
This button is used when installing the air
conditioner and should not be used under
normal conditions as it will cause the air
conditioner’s thermostat function to oper-
ate incorrectly.
●
If this button is pressed during normal op-
eration, the unit will switch to test opera-
tion mode, and the indoor unit’s OPERA-
TION indicator lamp and TIMER indicator
lamp will begin to flash simultaneously.
●
To stop the test operation mode, either
press the TEST RUN button once again, or
press the START/STOP button to stop the
air conditioner.
U
Remote Control Unit Display (Fig. 8)
V
Transmit Indicator
W
Clock Display
X
Operating Mode Display
Y
T imer Mode Display
Z
Fan Speed Display
[
Temperature Set Display
\
T imer Set Indicator
]
Temperature Set Indicator
