En-5
Fig. 1 Indoor Unit
1
Operating Control Panel (Fig. 2)
2
MANUAL AUTO button
3
Remote Control Signal Receiver
4
Indicator Lights (Fig. 3)
5
OPERATION Indicator Light (red)
6
TIMER Indicator Light (green)
7
SWING Indicator Light (orange)
(VERTICAL SWING)
8
SWING Indicator Light (orange)
(HORIZONTAL SWING)
●
If the TIMER indicator light flashes when
the timer is operating, it indicates that a
fault has occurred with the timer setting
(See page 16 Auto Restart).
9
Intake Grille (Fig. 4)
0
Air Filter
A
UP/DOWN Air Direction Flaps
B
RIGHT/LEFT Air Direction Louvers
(behind UP/DOWN Air Direction Flaps)
C
Drain Hose
D
Air Cleaning Filter (optional)
Fig. 5 Outdoor Unit
E
Intake Side
F
Outlet Side
Fig. 6 Remote Control Unit
G
SLEEP Button
H
MASTER CONTROL Button
I
SET TEMP./SET TIME Buttons (
)
J
Signal Transmitter
K
TIMER Button
L
FAN CONTROL Button
M
START/STOP Button
N
Battery compartment lid
Inside of the battery compartment lid (Fig. 7)
O
AIR FLOW DIRECTION Button
P
ENERGY SAVE Button
Q
CODE CHANGE (Slide Switch)
Switching the remote control unit code.
(Max. 4 units)
R
TIME ADJUST Button
S
TEST RUN Button
●
This button is used when installing the air
conditioner and should not be used under
normal conditions as it will cause the air
conditioner’s thermostat function to oper-
ate incorrectly.
●
If this button is pressed during normal op-
eration, the unit will switch to test opera-
tion mode, and the indoor unit’s OPERA-
TION indicator light and TIMER indicator
light will begin to flash simultaneously.
●
To stop the test operation mode, either
press the TEST RUN button once again, or
press the START/STOP button to stop the
air conditioner.
T
ACL Button
U
Remote Control Unit Display (Fig. 8)
V
Transmit Indicator
W
Clock Display
X
Operating Mode Display
Y
Timer Mode Display
Z
Fan Speed Display
[
Temperature Set Display
\
Timer Set Indicator
]
Temperature Set Indicator
