3
°
C
NON STOP
CLOCK
TEMP
AUTO
TIMER
MODE
SET
ZONE
START/STOP
CLOCK ADJUST
SET TIME
TEMP./DAY
FAN
CONTROL
MASTER
CONTROL
2
1
HIGH
AUTO
COOL
DEFROST TEST
DAY OFF
ENERGY SAVE
°
C
NON STOP
CLOCK
TEMP
AUTO
TIMER
MODE
SET
ZONE
START/STOP
CLOCK ADJUST
SET TIME
TEMP./DAY
FAN
CONTROL
MASTER
CONTROL
2
1
HIGH
AUTO
COOL
DEFROST TEST
DAY OFF
ENERGY SAVE
1
2
CLOCK
2
1
Set the Current Time and Day
1
Press the CLOCK ADJUST button for more than three
seconds.
2
Press the SET TEMP./DAY button and set the day.
▲
: Use to advance the day forward.
▼
: Use to turn the day back.
The day is indicated by a code number from 1 to 7, as shown in the table
below. Set to the number that corresponds to the current day.
DAY CODE
1
2
3
4
5
6
7
DAY OF THE WEEK
MON
TUE
WED
THU
FRI
SAT
SUN
3
Press the SET TIME button and set the time.
▲
: Use to advance the time forward.
▼
: Use to turn the time back.
(Press once to move the time 1 minute; hold down and the time will move
10 minutes at a time.)
4
Press the CLOCK ADJUST button again.
This registers the new day and time values. The day display goes off, and
the time display stops flashing.
PREPARATION
CLOCK
DAY
AUTO
TIMER
MODE
SET
ZONE
START/STOP
CLOCK ADJUST
SET TIME
TEMP./DAY
FAN
CONTROL
MASTER
CONTROL
2
1
AUTO
DEFROST TEST
DAY OFF
ENERGY SAVE
3
2
1
Instructions relating to heating (*) are applicable only to “HEAT & COOL MODEL” (Reverse Cycle).
To Select Mode Operation
1
Press the START/STOP button.
The unit will start and the remote controller’s operation lamp (green) will
light up.
2
Press the MASTER CONTROL button to select the de-
sired mode.
*HEAT
FAN
COOL
To Set the Thermostat
Press the SET TEMP./DAY button to the desired temperature.
▲
:
Press to raise the thermostat setting.
▼
:
Press to lower the thermostat setting.
●
Thermostat setting range:
* Heating ............................... 16 °C to 30 °C
Cooling ............................... 18 °C to 30 °C
The thermostat cannot be used to set room temperature during the FAN mode
(the temperature will not appear on the remote controller’s display).
The thermostat setting should be considered a standard value, and may
differ somewhat from the actual room temperature.
To Stop Operation
Press the START/STOP button.
The remote controller’s operation lamp (green) will go out.
The display contents disappear and only the current time is displayed.
OPERATION
Example:
Set the time to 9:31.
c
c
c
Example:
When set to COOL
Example:
When set to 26 °C
