En-6
To Stop Ope
r
at
i
o
n
P
r
ess t
h
e START
/
STOP
bu
tto
n.
The OPERATION Indicator Lamp will go out.
A
b
o
u
t AUTO CHANGEOVER Ope
r
at
i
o
n
AUTO:
●
When AUTO CHANGEOVER is selected, the air conditioner selects the
appropriate operation mode (Cooling or Heating) according to your room’s
present temperature.
●
When AUTO CHANGEOVER operation rst selected, the fan will operate
at low speed for about a few minute, during which time the indoor unit de-
tects the room conditions and selects the proper operation mode.
If the difference between thermostat setting and actual room temperature
is more than +2 °C
o
Cooling operation
If the difference between thermostat setting and actual room temperature
is within ±2 °C
o
Determined by outdoor temperature
If the difference between thermostat setting and actual room temperature
is more than –2 °C
o
Heating operation
●
When the air conditioner has adjusted your room’s temperature to near
the thermostat setting, it will begin monitor operation. In the monitor op-
eration mode, the fan will operate at low speed. If the room temperature
subsequently changes, the air conditioner will once again select the ap-
propriate operation (Heating, Cooling) to adjust the temperature to the
value set in the thermostat.
●
If the mode automatically selected by the unit is not what you wish, select
one of the mode operation (HEAT, COOL, DRY, FAN).
A
b
o
u
t Mo
d
e Ope
r
at
i
o
n
Heat
ing
:
●
Use to warm your room.
●
When Heating mode is selected, the air conditioner will operate at very
low fan speed for about 3 to 5 minutes, after which it will switch to the se-
lected fan setting. This period of time is provided to allow the indoor unit
to warm up before beginning full operation.
●
When the outdoor temperature is very low, frost may form on the outside
unit, and its performance may be reduced. In order to remove such frost,
the unit will automatically enter the defrost cycle from time to time. Dur-
ing Automatic Defrosting operation, the OPERATION Indicator Lamp will
ash, and the heat operation will be interrupted.
●
After the start of heating operation, it takes some time before the room
gets warmer.
Coo
ling
:
●
Use to cool your room.
D
r
y:
●
Use for gently cooling while dehumidifying your room.
●
You cannot heat the room during Dry mode.
●
During Dry mode, the unit will operate at low speed; in order to adjust
room humidity, the indoor unit’s fan may stop from time to time. Also, the
fan may operate at very low speed when adjusting room humidity.
●
The fan speed cannot be changed manually when Dry mode has been
selected.
Fa
n
:
●
Use to circulate the air throughout your room.
D
uring
Heat
ing
mo
d
e:
Set the thermostat to a temperature setting
that is higher than the current room tem-
perature. The Heating mode will not oper-
ate if the thermostat is set lower than the
actual room temperature.
D
uring
Coo
ling/
D
r
y mo
d
e:
Set the thermostat to a temperature setting
that is lower than the current room tem-
perature. The Cooling and Dry modes will
not operate if the thermostat is set higher
than the actual room temperature (in Cool-
ing mode, the fan alone will operate).
D
uring
Fa
n
mo
d
e:
You can not use the unit to heat and cool
your room.
OPERATION
9374379453_OM_EN.indd 6
12/3/2010 4:31:05 PM
