Fujitsu Siemens Computers D1171, Technical Manual

Page: 20 / 20

Upgrading main memory
12 - English
A26361-D1171-Z180-4-7619
Upgrading main memory
Support: The system needs at least one module and can manage at most two SDRAM
modules.
Size: From 16 Mbytes up to 512 Mbytes SDRAM
Technology: 100 MHz unbuffered DIMM modules.
168 pin, 3.3 V, 64 bit, 100 MHz SDRAM
2 M, 4 M, 8 M, 16 M and 32 M x 64 bit
Granularity: For one socket 16, 32, 64. 128 or 256 Mbyte
SDRAM modules with ECC can be plugged in but ECC is not functioning. Mix of
ECC modules with non ECC modules is possible.
Troubleshooting
Message BIOS update
The System BIOS provides optimum support for the processor you have chosen. If the message
BIOS update for installed CPU failed
appears the microcode required for the processor inserted must still be loaded. Further information
on this is available in the "BIOS Setup" manual on the "Drivers & Utilities" CD provided.
The screen stays blank
If your screen stays blank this may have the following cause:
The wrong RAM memory module has been inserted
Ê
See the chapter "Main Memory" for information which memory modules can be used.
ACPI S3 (Save-to-RAM) and/or ACPI S4 (Save-to-Disk) doesn't work
This system board is fully compliant for ACPI S3 and S4. Therefore it is PC98 certified by Microsoft.
If you have any problems with ACPI please ensure that all of your components are supporting ACPI
S3 and S4.
−
Operating system
−
Hardware and drivers of controllers (e. g. VGA, audio, LAN, SCSI controllers).
!
The system board D1171 supports Save-to-RAM. Therefore the D1171 is certified by Intel
and Microsoft. This support must be also guaranteed by the operating system, the
extension boards and the power supply. For the time neither Windows 98 1st edition nor
Windows NT4.0 support this function reliably. Windows 98 SE and Windows 2000 will
support ACPI S3. Unfortunately only a few extension boards work with functional Save-to-
RAM compliant drivers (refer to
http://developer.intel.com/technology/iapc/involve.htm
).