Fujitsu Siemens Computers AMILO Pro V2030, Getting Started, Page: 26 / 27

Troubleshooting and tips
18 A26391-K183-Z100-1-7619, edition 2
The printer does not print
► Make sure that the printer is switched on and is on-line (see the manuals supplied with the
printer).
► Check that the cable connecting the notebook and the printer is connected properly.
► Check whether the correct printer driver is loaded (see printer documentation).
Acoustic warnings
A beep sounds every few seconds.
The battery is almost flat.
► Charge the battery.
Error messages on the screen
This section describes the error messages generated by the BIOS Setup Utility . Error messages
displayed by the operating system or programmes are described in the relevant documentation.
CMOS Battery Bad
If the error message occurs repeatedly, the buffer battery in the notebook is flat.
Contact your sales outlet or our hotline/help desk.
System CMOS checksum bad - Default configuration used
The system configuration information is incorrect.
► Switch the notebook off.
► Switch the notebook on.
► Enter the
BIOS Setup Utility
by pressing F2 .
► Select the entry
Load Setup Defaults
.
► Mark
OK
.
► Press the Enter key.
If the error message appears repeatedly, please contact the place of purchase or our
hotline/help desk.
Extended memory failed at offset: xxxx Failing Bits: zzzz zzzz
When testing the extended memory an error has resulted at the address xxxx.
► Check whether the additional memory module has been inserted correctly.
If the error message appears repeatedly, please contact the place of purchase or our
hotline/help desk.