Fujitsu Siemens Computers AMILO D 6800, Operating Manual, Page: 63 / 82

Troubleshooting and tips
440 N00072
53
System configuration contains invalid data
Ê
Switch the notebook off.
Ê
Switch the notebook on.
Ê
Enter the BIOS Setup programme by pressing [F2] .
Ê
Select the default values under Load Default Settings .
Ê
Mark Yes in the Do you want to load default settings? dialogue box.
Ê
Press the Enter key.
If the error message appears repeatedly, please contact the place of purchase or our
hotline/help desk.
Error messages on the screen
This section describes the error messages generated by the
BIOS-Setup
. Error messages displayed
by the operating system or programmes are described in the relevant manuals.
CMOS Battery Bad
If the error message occurs repeatedly, then the buffer battery in the notebook is flat.
Ê
Connect the notebook via its power adapter to the mains outlet. The buffer battery will take
approximately two days to complete its recharge.
If the error message appears repeatedly, please contact the place of purchase or our
hotline/help desk.
System CMOS checksum bad - Default configuration used
The system configuration information is incorrect.
Ê
Switch the notebook off.
Ê
Switch the notebook on.
Ê
Enter the BIOS Setup programme by pressing
[F2]
.
Ê
Select the Default Setting entry.
Ê
Click on
OK
.
If the error message appears repeatedly, please contact the place of purchase or our
hotline/help desk.
Insert system diskette and press Enter key to reboot
The operating system cannot be loaded or the hard disk contains no operating system or is not
formatted.
Ê
Insert a system disk.
Ê
Press any key to continue.