04/2008
These instructions should be used for Wellborn Accessory Kits
CWHFLK36-CWHFLK48. (Page 3 of 4)
MODEL: BUF-06W
1U03 1381
Range Hood
Tighten screws to fix
Liner
Screw-washer
[Right & left,
each two (2) places]
[Securing plate turns
while passing through
the opening of Liner]
Securing plate
Four screws (M5
×
30)
Liner
INSTALLATION
1. Preparation
2. Range Hood Mounting
5
Tighten both the left and
right screws, and fix the
range hood securely
adding 4 more supplied
washer head wood
screws to the holes on
the hangers and back of
the range hood.
1
This range hood is
designed to discharge
upward. For vertical
discharge, run duct work
between the hood location
and roof cap location.
To get the best result, use
a minimum number of
transitons and elbows.
Be sure to attach a roof
cap to avoid rain from
entering the exhaust duct.
2
The range hood unit must be mounted to a liner which has the
following dimensions. Install the liner securely after checking that
the opening size of the liner is the same as the figure below.
• Ensure that the metal duct does not touch other metal housing
materials, otherwise fire or electric shock could result.
• The liner should be installed tightly. If the liner installation is not
correct, the range hood unit may become detached and fall.
• Wear working gloves to avoid injury.
CAUTION:
3
Hold up the range hood and align the 4 screw holes of the liner
and range hood, then fix securely using the supplied screws
(M5
×
30) and nuts.
Note: Fasten all the screws and nuts evenly.
CAUTION:
WARNING:
Unit: inch (mm)
2
Detach the filters by loosening 2 screws. Remove 5 screws
fixing the front cover and detach the front cover.
26" (660)
15-15/16" (405)
25-3/16" (640)
9-13/16" (250)
4-
∅
1/4" (4-
∅
6.5)
Screw
Tape
Hanger
Non-flammable tape
Wood panel
Liner
Fan unit
Wall
3
Make sure that a wood panel for
mounting the range hood is fixed
on the wall where the range hood
is installed.
Note: If no wood panel is found
on the wall, be sure to
prepare one referring to the
figure.
4
Referring to “DIMENSIONS” above,
insert 2 supplied wood screws into
the mounting wall for the left and
right hangers. Allow about 5mm
space between the wall and screw-
heads for hanging.
5mm
4
With inserting the exhaust
port into the duct, hook
both the left and right
hangers on the screws
provided in “Preparation”
step 4.
6
Make the duct joint secure
and air-tight using non-
flammable tape such as duct
tape, etc. (Not supplied)
Roof cap
7" round duct
(For vertical discharge)
Range hood
Soffit
1
Detach the tape on the exhaust port.
