· Always store the unit inside in a dry location. Store on the floor if in a
basement setting.
· The operator must wear shoes and the floor must not be wet.
FIRE AND EXPLOSION HAZARD
Turbine must not be used in an area contaminated by volatile or
flammable materials since sparking can be expected in the
normal operation of the motor. This could ignite the contami-
nants causing a dangerous explosion.
· Do not spray flammable or combustible materials near an open flame
or sources of ignition such as cigarettes, motors, and electrical
equipment.
· Keep spray area well-ventilated. Keep a good supply of fresh air
moving through the area. Keep turbine in a well ventilated area.
· Do not spray turbine.
· Turn off and disconnect power cord before servicing equipment.
· Do not smoke in the spray area.
· Do not operate light switches, engines, or similar spark producing
products in the spray area.
· Keep area clean and free of paint or solvent containers, rags, and
other flammable materials.
· Fire extinguisher equipment shall be present and working.
· Sprayer generates sparks. When flammable liquid is used in or near
the sprayer or for flushing or cleaning, keep sprayer at least 20 feet
(6 m) away from explosive vapors or spraying area.
· Ensure ground prongs are intact on sprayer and extension cords.
· Always disconnect unit from main supply when filling the paint
container.
TOXIC FLUID OR FUMES HAZARD
Toxic fluids or fumes can cause serious injury or death if
splashed in the eyes or on skin, inhaled, or swallowed.
· Read MSDS (Material Safety Data Sheet) to know the specific
hazards of the fluids you are using.
· Always wear appropriate gloves and eye protection
· Always wear a respirator or mask. Read all instructions of the
respirator or mask to ensure that it will provide the necessary
protection against the inhalation of harmful vapors. Please also check
with the local jurisdiction.
3
22
GUN HOLDER INSTALLATION
The 2 holes on the top of the Holder require the 2 Machine Screws
and Washers. These Screws fit into Threaded Inserts in the Metal
Case. Do not over tighten - snug is fine.
The single Silver-Colored Screw must be installed to the single hole
on the side of the Gun Holder. Once again, please do not over
tighten this screw - snug is fine.
If you do not intend on using the Gun Holder you may insert the
appropriate screws (as mentioned above) to block the holes.
GUN HOLDER USE
Place the Hose Connector (base of the Gun Handle) over the shaft of
the Gun Holder shown in above illustration. Please ensure it is fully
set down to the base of the shaft. The Spray Gun will now sit station-
ary. The Gun can be left on the Holder for any length of time. It is a
convenient resting place between spraying and ideal for filling the
Gravity Cup.
GUN HOLDER & FILLING STATION
