FujiFilm FinePix FinePix S9600, Service Manual

Page: 69 / 154

4-1
4. Adjustments
FinePix S9100/S9600 Service Manual
4. Adjustments
4-1. Important point Adjustment when Replacing Major Parts
Adjust the item shown by { in the table below at the part replacement of LENS ASSY, MAIN PWB, DCST PWB, AF-SENSOR
and FLASH CONST. (Other part replacements need not be adjusted.)
Measuring equipment Remarks
Regulated power supply For adjustment
Pattern box PTB450F
Digital voltmeter For Battery adjustment
PC Used for various adjustments and operation checks (PC-AT compatible, Win 2000 / XP) *1
It is necessary to install Microsoft .NET Framework Ver1.1.
*2
Brightness meter LS-110 (Minolta) or equivalent
Color temperature meter Color Meter IIIF (Minolta) or equivalent
Flash meter Used for function checks
xD-Picture Card (64MB or more) For CCD Line Defect Adjustment
DPC-R1 For CCD Line Defect Adjustment
*1: PC condition
1. Hardware recommendation: CPU;Pentium4 2.4GHz or better, RAM;512MB or more.
It might make an error of the adjustment when the performance of PC is low.
2. Video Jig must be installed.
*2: Download it from the homepage of the Microsoft.
Microsoft .NET Framework Version 1.1
http://www.microsoft.com/downloads/details.aspx?familyid=262d25e3-f589-4842-8157-034d1e7cf3a3&displaylang=en
Replacing parts
Adjustment item
LENS ASSY MAIN PWB DCST PWB AF-SENSOR FLASH CONST
0 Flash memory reset* {
1 AF-Sensor adjustment { {
2 CCD Data Input { {
3 Camera adjustment { {
4 CCD Line Defect adjustment { {
5 Shading compensation adjustment { {
6 AF adjustment { {
7 Flash adjustment { { { {
8 Battery adjustment { { {
9 Mode dial adjustment { {
10 Video adjustment { {
11 Firmware download Do not use it until there is an instruction.
12 End setting (Do the end setting when you end the adjustment software when you set the camera to the Jig mode)
* When the MAIN PWB ASSY is replaced, the camera will not operate normally unless the MAIN PWB is initialized.
4-2. Measuring Instruments Used