FujiFilm DR-ID 1300, Service Manual

Page: 69 / 628

MD-4
MD-4
DR-ID 1300 / DR-ID 1300PU Service Manual
018-234-03E
1.3.2 Electric parts
n
SE rear
Top Bottom
Center
<1305SE>
1300_100004.ai
(D) (A) (A) (H)
(D) (A) (A) (H)
(F)
(G)
(E) (E)
(E)
(I)
(I)
(I)
(A)
(C)
(C) (C)
(B)
(B)
(B)
(B)
(B)
(B)
The shading in the following table indicates parts for which market replacement is not
possible.
No. Name 1305SE Function Description
(A) GTD 65A
The gate control signal (charge read switch) received from
the RMV board is amplified and sent to the gate control IC.
(B) ABA 65A
The analog signal read from the panel is converted to a
digital signal and sent to the RMV board.
(C) RMV 65A
- Control of image reading. The image data received from
the ABA board are subjected to compensation processing
and are sent to the MC.
- With each image acquisition completion, the temperature
in the panel is monitored by Thermistor.
- Control of wired communication with the panel outside.
- Control of each board in the panel, based on requests
from the MC (battery monitoring, LED control, shock
sensor control, SE application update, log output to the
FTP server, etc.).
- Perform command communications between the RMV
boards for each panel unit.
(D) LED 65B Lighting of the panel LED (status lamp)
(E) POW 65A Supply of the DC power for the boards in the panel.
(F) POD 65A
- Convert the SE input power 24 V DC into the power supply
for the panel system 12 V, into the power supply for the
PDV, and into the power supply for the HUB 5 V.
- Relay the LED control signal from the RMV board to the
LED board.
(G) HUB - Connect each board in the panel with LAN cables.
(H) LED 65C Lighting for each panel selection READY LED.
(I) COC 65A
Separate control signals for each panel selection READY
LED from the RMV65A board.