FujiFilm DR-ID 1300, Service Manual

Page: 118 / 628

MC-5
MC-5
DR-ID 1300 / DR-ID 1300PU Service Manual
018-234-06E
2.3 MPC54B Board
u
INSTRUCTIONS
u
- Refer to the following procedures for replacing the MP (when two MP have been
installed, the MP2 is also included) MPC54B board whose local IP address is
changed from the default value.
{MC:2.12_Replacing the MP whose Local IP Address Is Changed}
- When replacing the MPC54B board, refer to the following procedures for updating
MP application software version.
{IN1:10.5_Updating MP Application Software Version}
{IN2:10.5_Updating MP Application Software Version}
n
Board Location
1200_300008.ai
DETAIL A
MPC54B board
A
n
Removal Procedures
(1) Remove the covers of the MP.
{MC:2.1_MP Cover}
(2) Remove the MPC54B board.
#1 Disconnect: Cable connectors (MPC1, 12, 13, 18, 21)
#2 Remove: M3x6 (x8)
1200_300011.ai
MPC12
MPC13
MPC18
MPC21 MPC1
#1
#2
NOTE
The LAN connector’s height has been changed for the MPC54B board’s L versions
or later. In the DR-ID 1300MP, when replacing the boards for J versions or earlier to
boards for the L versions or later, also replace the brackets which are attached to the
LAN connector.
1200_300221E.ai
Older board (J version or earlier)
Older board bracket
Newer board (L version or later)
Newer board bracket
n
Reinstallation Procedures
Reverse the removal procedures for reinstallation.