26
4 Maintenance
Transfer Unit
Note
Before pulling out the Transfer Unit, check the screen display for any remaining paper in the left and right
covers of the machine, Paper Tray 5 (Bypass), Exit, or optional High Capacity Feeder and Finisher. If the
Transfer Unit is pulled out while paper is remaining in any of these locations, the paper may become torn.
Do not touch locations that are not mentioned in the steps. The inside of the machine may become
stained, and smears may appear on the printed output.
1.
Open the Front Cover.
2.
Turn the handle [2] of the Transfer Unit to the right until it
becomes horizontal (
) and pull the Transfer Unit out to the
front until it stops (
).
3.
Slowly pull out the paper in the arrow direction and remove
it.
Note
When the paper is torn, confirm that no paper pieces remain.
Do not push the paper in the direction opposite to the arrow
and/or pull it to the front.
4.
Perform the following operation according to the instructions displayed on the screen.
[2a]
1)
Open the handle [2a] (
) and remove the jammed paper
(
).
Note
If you cannot check the paper, you may be able to check it if
looking into it from underneath.
WARNING
The Fusing Unit is hot. It may cause burn injury. Do not touch this unit.
1
2
1
2
