Fuji Xerox DocuPrint CM505 da, Administrator'S Manual

Page: 179 / 599

Connectivity & Network Setup
179
T
ools
5
„ Digital Signature - Outgoing Internet Fax
Select whether or not to always add a digital signature to outgoing Internet faxes.You can
also select the setting in which the machine asks to add a digital signature to the Internet fax
whenever you send.
„ Certificate Auto Store
Select whether or not to automatically store a S/MIME certificate attached with the e-mail
when receiving e-mail from an address registered on the Address Book.
PDF / DocuWorks / XPS Signature Settings
Configure signature settings of PDF / DocuWorks / XPS documents.
„ Device Certificate
Select a certificate to use for the signature.
For more information on the certificate, refer to "Encryption and Digital Signature Settings" (P.311).
„ PDF Signature
Select the setting for PDF Signature from [Do not add signature], [Always add visible
signature], [Always add invisible signature], or [Select during send].
„ DocuWorks Signature
Select the setting for DocuWorks Signature from [Do not add signature], [Always add
signature], or [Select during send].
„ XPS Signature
Select the setting for XPS Signature from [Do not add signature], [Always add invisible
signature], or [Select during send].
IPSec Settings
Configure the IPSec settings.
Note • For [IKE Authentication Method], [Preshared Key], [DH Group], and [PFS Settings], consult
your network administrator.
„ IKE Authentication Method
Set the IKE authentication method. Select from [Authenticate by Preshared Key] and
[Authenticate by Digital Signature].
„ Preshared Key
Enter a preshared key.
This setting is valid when [IKE Authentication Method] is set to [Authenticate by Preshared
Key].
„
Device Certificate
Select a certificate for IPSec communications.
Set a certificate when [IKE Authentication Method] is set to [Authenticate by Digital
Signature]. A self-signed certificate created by CentreWare Internet Services cannot be used.
For more information on a certificate, refer to "Types of Certificate" (P.312).
„ IPSec Communication
Select whether or not to enable IPSec communications.
„ IKE SA Life Time
Specify IKE SA lifetime from 5 to 28800 minutes in 1 minute increments.
Note • The value must be greater than the value set in [IPSec SA Life Time].
„ IPSec SA Life Time
Specify IPSec SA lifetime from 300 to 172800 seconds in 1 second increments.
Note • The value must be smaller than the value set in [IKE SA Life Time].
„ DH Group
Set DH group. Select from [G1] and [G2].