Fuji Xerox Document Centre C250, User Manual

Page: 156 / 556

5 Scan
154
Scan
5
Scanning Procedure
This section describes basic scan operations. The following shows the scanning
procedure and reference sections.
Step 1 Loading Documents .......................................................................................................154
Step 2 Selecting Features ..........................................................................................................156
Step 3 Starting the Scan Job......................................................................................................157
Step 4 Confirming the Scan Job in the Job Status ....................................................................158
Step 5 Saving the Scanned Data ...............................................................................................159
Step 1 Loading Documents
There are two methods for loading documents:
„
Document Feeder
z Single sheet
z Multiple sheets
„
Document Glass
z Single sheet
z Bound documents, such as books
Document Feeder
The document feeder supports single sheet and multiple sheet documents, with sizes
ranging from 148.6 × 210mm (A5, A5 ) to a maximum of 297 × 432mm
(A3, 11 × 17 inches).
The document feeder can auto-detect only documents of standard sizes. For non-
standard size documents, enter the size in the [Scan Size] field.
The document feeder accept the following number of sheets.
For information about entering a custom size, refer to "Scan Size (Specifying a Scanning Size)" (P.179).
For information about scanning documents of mixed size, refer to "Mixed Size Originals (Scanning
Different Size Documents Simultaneously)" (P.179).
Important • Place folded or creased documents on the document glass to avoid paper jams.
• 2 sided scanning of lightweight paper documents (38-48g/m
2
) is not supported.
Document Type (weight)
Number of
sheets
Lightweight paper (38-49g/m
2
) 75 sheets
Plain paper (50-81g/m
2
) 75 sheets
Heavyweight paper (81-128g/m
2
) 50 sheets