Fuji Xerox DOCUCENTRE-II C3000, User Manual

Page: 271 / 603

Common Settings
269
Sy
st
em Set
tin
gs
11
Copy Job Complete Tone
Select the sound to be made when a copy completes normally.
You can select the volume from [Soft], [Normal], and [Loud]. To disable the sound, select
[Off].
Non-Copy Job Complete Tone
Select the sound to be made when a job other than copying completes.
You can select the volume from [Soft], [Normal], and [Loud]. To disable the sound, select
[Off].
Fault Tone
Select the sound to be made when an error termination occurs.
You can select the volume from [Soft], [Normal], and [Loud]. To disable the sound, select
[Off].
Alert Tone
Select the sound to be made when a fault such as a paper jam occurs, and the fault is left
unattended to.
You can select the volume from [Soft], [Normal], and [Loud]. To disable the sound, select
[Off].
Out of Paper Warning Tone
Select the sound to be made when a job is suspended due to running out of paper in a tray.
You can select the volume from [Soft], [Normal], and [Loud]. To disable the sound, select
[Off].
Low Toner Alert Tone
Select the sound to be made when the toner cartridge needs to be replaced.
You can select the volume from [Soft], [Normal], and [Loud]. To disable the sound, select
[Off].
Line Monitor Volume
You can relay the sound on the telephone circuit in the interval from dialing until the
connection is made through the speakers on the machine. This is convenient for using Fax
Information Services without using the telephone.
You can select the volume from [Soft], [Normal], and [Loud]. To disable the sound, select
[Off].
Ringing Volume
Select the sound to be made when an incoming call arrives at the machine.
You can select the volume from [Soft], [Normal], and [Loud]. To disable the sound, select
[Off].
Stored Programming Tone
Select the sound to be made while a stored program is registered.
You can select the volume from [Soft], [Normal], and [Loud].
It is not possible to disable this sound.
Auto Clear Alert Tone
Select the sound to be made at 5 seconds before automatically returning to the initial screen,
when the auto clear feature is enabled.
You can select the volume from [Soft], [Normal], and [Loud]. To disable the sound, select
[Off].