5 Installation When Using NetWare
38
Inst
alla
tion W
h
e
n
Us
ing
Ne
tW
are
5
Preparations
Prepare the following items to install the machine when using NetWare network.
z
A NetWare server
z
TCP/IP or NetBEUI network environment
z
The "CentreWare Utilities" or "Driver CD Kit" CD-ROM: included with this product.
Installation Procedure
Installation Overview
The machine supports PServer mode both for the NetWare Directory Service and
Bindery Service. PServer mode enables the machine to function as a print server and
to capture print jobs in the print queue to output. The printer created for the machine
consumes one file server license.
Note
•
The machine does not support Remote Printer (RPrinter) Mode.
•
You can use the machine as a printer in a NDPS environment by using a Novell NDPS
Gateway. When using in a NDPS environment, settings of the machine to be used under a
NetWare print environment are required. Or, you need to enable LPD in advance and set it
as a gateway destination in a Novell NDPS Gateway setup. However, attribute information
that can be set or captured by NDPS is not supported.
■
Supported interfaces
z
100BASE-TX
z
10BASE-T
■
Supported frame types
z
Ethernet II specification
z
IEEE802.3 specification
z
IEEE802.3 / IEEE802.2 specification
z
IEEE802.3 / IEEE802.2 / SNAP specification
Note
•
The machine will send packets of each frame type on the network, and will initialize for the
same frame type as the first reply packet received. However, if there are multiple protocols
running on the same network, please use Ethernet II specification.
•
Some network equipment (hubs, etc.) may not support the automatic frame type detection. If
a data link indicator corresponding to the port of the network equipment connected with the
machine does not light up, change the settings of the frame type of the machine to the frame
type of the file server. Configuration can also be performed using CentreWare Internet
Services.
The following describes the configuration procedure to connect the machine to a
NetWare network.
z
Configuration on the Machine
- To use IPX/SPX, the machine is configured using the "CentreWare Utilities" or
"Driver CD Kit" CD-ROM after enabling the NetWare port of the machine.
- To use a LPD port in NDPS, the machine is configured using the "CentreWare
Utilities" or "Driver CD Kit" CD-ROM after enabling the LPD port of the machine
and setting TCP/IP.
z
Configuration on the computer
