Fuji Xerox DocuCentre 1055, User Manual

Page: 65 / 245

Fax Procedure
65
2.
Press the <Clear All> button on the
control panel once to cancel any
previous selections.
3.
Select an option for the required
feature.
If necessary, press the < > or < > button to switch between screens, and configure
the fax settings. For more information about Fax features available, refer to
Fax
Features on page 71 .
3. Specify the Destination
The following explains how to specify a destination. The machine provides the following
dialing methods for fax numbers.
NOTE: Before sending a document, check your entries to make sure you specified
correct destinations.
• Using the numeric keypad on the control panel
• Using Address Book (refer to Address Book on page 68 .)
• Using Speed Dial (refer to Speed Dial on page 69 .)
• Using One Touch Dial (refer to One Touch Dial on page 70 .)
1.
Enter the fax number using the numeric
keypad on the control panel.
You can send a fax to multiple destinations in
a single operation. For more information,
refer to
Address Enter/Next on page 68 .
If a character is usually dialed before the telephone number, for example 9 for an
external line, a pause is required after this character. Press the <Dial Pause> button on
the control panel before continuing to enter the fax number. When you dial manually,
Dial Pause is not required; instead wait for the external dial tone before proceeding.
NOTE: When [Line type] set under [Local Terminal Information] is a pulse line (10pps,
20pps) pressing the <*> button allows pulses to be recognized as tones. When the
tone is recognized, the <#> button and * can be entered in the same way as with a
tone line.
<Clear All> button
<Dial Pause> button