Fuji Xerox ApeosPort-VII C5588, Quick Reference

Page: 81 / 247

Loading Paper
81
6
Likewise, load the remaining postcards and align the edges of the postcards in the arrow
direction (1). Hold the short-side paper guide on the left side and slide it to the desired
paper size (2).
Important
z
Do not load paper exceeding the maximum fill line. It might cause paper jams or device malfunctions.
z
If the number of sheets is 100 or less, the paper guides touch too tightly against the paper, causing the paper
to deform and resulting in paper jams.
z
Position the paper guides correctly to match the paper size. If the position of the guide is not correct, the
paper may not be fed properly, causing paper jams.
7
Push the tray in gently until it stops.
Note
z
When removing the Post Card Kit from the tray, completely loosen the screw before removing the kit. Place
the removed Post Card Kit back to its original location (1). Then, tighten the screw (2).
Loading Envelopes in Tray 6 (High Capacity Feeder B1-S) or Trays 6 and
7 (High Capacity Feeder C1-DS)
The following describes the procedure for loading envelopes in Tray 6 (High Capacity
Feeder B1-S (optional)) or Trays 6 and 7 (High Capacity Feeder C1-DS (optional)).
The following sizes of envelopes can be loaded.
z
Standard Size
- No.3 standard envelopes (120 x 235 mm)
- No.2 standard envelopes (240 x 332 mm)
- C5 (162 x 229 mm)
- C4 (229 x 324 mm)
z
Non-Standard Size
- Width (Y) 100 - 330 mm, length (X) 148 - 488 mm