Fuji Xerox ApeosPort-V 4020, Administrator'S Manual, Page: 377 / 611

Trouble during Faxing
377
Pro
b
lem
Solvi
n
g
14
Trouble during Faxing
This section describes how to resolve fax problems.
Note • For troubles during Internet faxing, refer to "E-mail Features Problems" (P.388).
Sending Problems
If you cannot send a fax, identify the symptom in the following table to perform the remedy.
Symptom Cause Remedy
A Transmission
Report - Job
Undelivered is
output. The fax was not sent because
of an error. Check the Transmission Results in the
Transmission Report - Job Undelivered. If an
error code is displayed, refer to "Error Code"
(P.395).
Unable to
communicate
(general fax) The phone line is not
connected correctly. Communication is enabled only when the
phone line is connected to the correct
connector.
When the cable connection is correct, the On-
hook feature allows you to call via general
lines.
The phone dialing method is
not available. Specify the same dialing method as the one
(Tone/10pps) subscribed for the machine.
An error occurred with the
phone line. Use a telephone near the machine to check
whether you can make a phone call. If the
phone call is disabled, the problem is in the
phone line, not in the machine.
The destination machine is
abnormal. The data cannot be sent if the machine of
the recipient is turned off, is set to "manual"
receiving mode, or does not support G3
reception.
Call the recipient to confirm the machine
condition.
An incorrect fax number is
used. Check the fax number and try sending again.
The number is not for fax
number. If no peep sound is heard from the receiver
when you call the number, the number is not
for a fax number.
You forgot the external
access number. When calling from an extension line, the
external access number is required.
When dialing, dial the external access
number such as "0", and then dial the fax
number.
When the switchboard is changed and you
cannot send faxes, try the external access
number "0*" instead of "0".