Fuji Xerox apeosport-iv C3370, Administrator'S Manual

Page: 394 / 889

E-mail Environment Settings
394
E-m
a
il Environm
ent S
e
ttings
8
obtained automatically or manual configuration is preferred, confirm the settings of an IP
address, a subnet mask, and a gateway address.
Reference
z
For information on how to set an IP address, refer to "Protocol Settings" (P.239).
4
Select [Close] repeatedly until the [Tools] screen is displayed.
5
Select [Close].
Note
z Rebooting the machine may be required depending on the settings. When a message displayed on the
screen, follow the message and reboot the machine.
6
Print a configuration report to confirm that the ports are enabled and that TCP/IP is set up
correctly.
Reference
z For information on how to print a configuration report, refer to "Print Reports" (P.131).
Step 2 Configuring E-mail Environment
The following describes the configuration procedures to use the E-mail features.
Reference
z You can configure the settings using CentreWare Internet Services. For the items that can be configured using CentreWare
Internet Services, refer to "CentreWare Internet Services Setting Items" (P.396).
z
For information on how to start CentreWare Internet Services, refer to "Starting CentreWare Internet
Services" (P.368).
1
Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator's user ID with the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator's passcode,
and select [Enter].
Note
z The default user ID is "11111".
z The default passcode is "x-admin".
3) Select [Tools] on the Services Home screen.
2
Set up the e-mail address of the machine.
1) Select [Connectivity & Network Setup].
2) Select [Machine's E-mail Address/Host Name], and then configure items.
Reference
z For information on how to set an e-mail address, refer to "Machine’s E-mail Address/Host Name" (P.243).
3) Select [Close] repeatedly until the [Tools] screen is displayed.
3
Set up the protocol to receive e-mails.
1) Select [Connectivity & Network Setup].