Fuji Xerox apeosport-IV 6080, Administrator'S Manual

Page: 688 / 705

16 Appendix
688
Ap
pe
ndix
16
On-hook Dialing
The following describes how to place a call with on-hook dialing. When placing a call,
we recommend that you turn the line monitor volume to "Loud".
The volume of the line monitor can be changed in the System Administration mode. For more
information on how to change the volume, refer to "Line Monitor Volume" (P.127). By factory default,
the volume is set to [Normal].
1
On the [Services Home] screen, select [Fax/
Internet Fax].
2
Select [On-hook (Manual Send/Receive)] on
the [More Options] screen.
3
Specify the call destination.
z
The call destination can be specified using the numeric keypad, address numbers,
or one-touch buttons. The Address Book cannot be used.
z
The call destination can be specified also
with the keyboard displayed on the screen.
Note • To disconnect the call, select [Line Cut].
• If your telephone line is set to touch-tone,
[Tone (:)] does not appear.
• If you want to send tones (or to use the
touch-tone services) while using a pulse
line, select [Tone (:)].
• Some touch-tone services may not be
available even if you set your telephone
to send tones.
4
When the call is connected, lift the receiver
and start speaking.
5
After the call is finished, place the receiver back in the cradle.
Important • Make sure that the receiver is placed properly in the cradle. Otherwise, the line remains
"busy".