42
INZ-TN2ZPAJ-E
$XWRFDOLEUDWLRQVWDWXVFRQWDFWRXWSXWLVFORVHGGXULQJDXWRFDOLEUDWLRQ12VLGHDQGLVRSHQLQRWKHUFDVHV
Remote start
:KHWKHUWKHDXWRFDOLEUDWLRQLVVHWDW21RU2))DQDXWRFDOLEUDWLRQLVDYDLODEOHE\UHPRWHVWDUW
LQSXW
When an auto calibration starts, the measurement screen appears automatically.
During auto calibration, any key operation is not permitted other than operations such
as key lock ON/OFF and “Forced stop of auto calibration” (see Section 6.4.2.2).
When the key lock is set at ON, even the “Forced stop of auto calibration” cannot be
performed. To cancel auto zero calibration forcedly, set the key lock to OFF and then
execute “Forced stop of auto calibration”.
Turn on the power again after it is turned off (including the case of power failure) at
the time set as the next start time in auto calibration, and then repeat it in the set cycle.
When the hold setting is set to ON, the hold time of auto calibration contact and
measurement value output signal are extended after calibration for gas replacement time.
Caution
Remote start input
Without input
With input (hold at least 1.5 sec.)
Start Time
Cycle
Flow Time
ON/OFF
SUN
1
Zero
Ch1 Span
Ch2 Span
Ch3 Span
Ch4 Span
EX. time
ON
12:00
day
350 sec
350 sec
350 sec
350 sec
300 sec
300 sec
(An example of “Ch1: through Ch4: enable”, as given in Section 6.2.4 “Setting of auto
calibration components/range”)
Flow time
: Auto calibration
Sunday
12:00
Cycle
Zero
calibration
(Ch1
4)
350sec
350sec
Ch1
Span
calibration
350sec
Ch2
Span
calibration
Ch3
Span
calibration
Ch4
Span
calibration
Monday
12:00
Tuesday
12:00
Example
In case where auto calibration is carried out at the above setting.
350sec
300sec
Replace-
ment time
300sec
Cycle
: 1 to 99 hours or 1 to 40 days (initial value 7 days)
Flow time
: 60 to 900 sec
(initial value 300 sec)
Setting range
