Installation Manual
Rail Mounting Base "RMA-C1"
Thank you for purchasing the rail mounting base "RMA-C1." The base allows you to install your FRENIC-Mini to a DIN rail 35 mm
(1.38 in) wide.
1. Check that:
(1) A rail mounting base is
contained in the package.
(2) The rail mounting base was not
damaged or dented during
transportation.
(3) The rail mounting base is the
model you ordered. You may
check the model name (see the
table below) printed on the
nameplate (shown at the right)
to ensure it matches your
inverter.
(4) If the rail mounting base is
model RMA-C1-2.2 or
RMA-C1-3.7, four screws
(M4x12) are also contained in
the package.
If you suspect the product is not
working properly or if you have any
questions about the product, contact
the shop where you bought the
product or your local FUJI branch
office.
RMA-C1-0.75
RMA-C1-2.2
RMA-C1-3.7
Nameplate
Nameplate
2. Rail Mounting Base Models and Applicable Inverter Models
Rail Mounting Base Models
Applicable Inverter Models
FRNF12C1S-2U
FRNF25C1S-2U
FRNF50C1S-2U
FRN001C1S-2U
FRNF12C1S-7U
FRNF25C1S-7U
FRNF50C1S-7U
FRN001C1S-7U
RMA-C1-0.75
FRNF12C1S-6U
FRNF25C1S-6U
FRNF50C1S-6U
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: [email protected]
