HOW IT WORKS
ENTERING VALUES
WARRANTY INFORMATION
WARRANTY: Your Fuelpak unit is warranted against defects
in materials and workmanship for the period of 90 days from
the original retail purchase. In the event of an alleged defect
in material or workmanship, Fuelpak’s responsibility is strictly
limited to repair or replace the defective product. Fuelpak shall
not be responsible for (a) labor, transportation, or other incidental
charges; (b) consequential or other damages incurred by use of
any product. Fuelpak offers no other warranty beyond this limited
warranty. This limited warranty does not apply to products which
have been (a) modified or altered in any way; (b) subjected to
adverse conditions, such as misuse, neglect, accident, improper
installation or adjustment, contaminants, corrosion, or faulty repair;
or (c) used in applications other than those recommended by Fuelpak. To
initiate a warranty process, the consumer must first call technical support
to receive a return authorization number. The product must be returned to
Fuelpak complete with a dated receipt and a return authorization number.
Fuelpak
Attn: Warranty Claims
13861 Rosecrans Avenue
Santa Fe Springs, CA 90670
(562) 921-0071
P/N 51660 111011
TECH
SUPPORT
IN THE EVENT OF A MALFUNCTION, PLEASE CHECK THE FOLLOWING
FUEL INJECTION MAN
A
GEMENT SY
STEM
1. Turn off main and handlebar switches then verify all
connectors are fully seated.
2. Be sure setting values are correct for your application.
3. With the engine running, verify the value in mode 52
changes when you twist the throttle
4. Check harness for cuts, scrapes or abrasions.
5. Make sure the battery is fully charged and the
charging system is operating correctly.
6. Call technical support at (562) 921-0071
1.
Remove Fuelpak snap cover by sliding tabs over the unit.
2.
Turn on
main
power and
handlebar
switches, but do not start engine. Fuelpak display should light up, if
not, turn power off and verify the connectors are fully seated.
3.
Refer to Fuelpak Map Lookup from www.fuelpakfi.com to locate the Setting Values specific to your bike and
exhaust system. If you do not find your setting reference online call tech support at (562) 921-0071
.
4.
Starting with mode 1 selected, press the value (+) or the value (-) buttons to input the correct value as
indicated in your Setting Value. After entering your first value, press the mode select button to move to mode
2 and enter the value. Continue until you have entered the value for each of the first 49 mode positions.
Each time the value (+) is pressed, the value increases by one number. Each time the value (-) is pressed, the
value decreases by one number. (Please refer to the “How It Works” section directly above if you have
questions about this step.
5
.
As the next procedure, after you have entered in your values for the first 49 modes, press the
mode select button to move to mode 50. Fully twist open the throttle and return to idle
position to calibrate the Fuelpak to your bike.
6.
Move to mode 52 and verify that it reads “0” with the throttle closed, “50” at approximately half-throttle and “99”
when fully opened; if not, repeat step 5. Do not proceed to step 7 until mode 52 is verified.
7.
Turn power off, wait one second then turn power back on. Verify all modes then turn power off.
8.
Reinstall snap cover.
9.
Reinstall seat. NOTE: Seat has rubber bumper on bottom, check clearance between Fuelpak and rubber bumper
during seat installation.
10.
You are now ready to ride.
