Fuel LB 600, User Manual

Page: 54 / 64

54
these expensive components. Failure to lubricate the deck at regular intervals may void the warranty.
The belt & deck come pre-lubricated and subsequent lubrication should be performed every 90 hours of use
or if you notice that the deck is dry. It is recommended that you reach be-tween the belt and deck to verify
there is lubrication present, every other month. If you check and there isn’t any lubrication present, follow
the procedure below even though the “Lube” indicator isn’t lit on the console. Otherwise, lubricate when the
console’s lubrication reminder lights after 90 hours of use. Use the following procedure to apply the silicone
lubricant:
1. Turn the power switch off and unplug the power cord from the wall outlet.
2. Measure 18” from the edge of the motor cover; kneel down and reach under the belt approximately
4-6” from one edge. Squirt a line of lubricant about 1/8” wide x 15” long in an “S” pattern
perpendicular to the motor cover.
3. Repeat the process on the opposite side.
4. Plug the electrical cord back into the outlet and turn the power switch on.
5. Walk on the belt at a moderate speed for five minutes to evenly distribute the silicone lube.
Note: If the “Lube” message appears on the console, perform the following procedure to
reset the message:
1. In standby mode, hold the ENTER key for 3 seconds to reset the message.
Error Messages
E0 Safety Key is not in place. A reminder to put in the safety key.
E1 Treadmill calibration did not receive a speed signal for 10 seconds.
E2 Over the rated current. The controller is over the rated current for 3 seconds.
Er Incline Error.
E4 Motor voltage surge or motor is disconnected.
E5 Communication is disconnected.
E6 Power malfunction.
Engineering Mode
First remove the Safety key, hold down the Program key and at the same time replace the safety key. The
treadmill’s console will enter Calibration mode.
1. Set wheel diameter to 60. Press the Enter key to confirm and move to the next item.
2. Set kilometers or miles. Press the Enter key to confirm and move to the next item.
3. Set the minimum speed of
1.0 . Press the Enter key to confirm and move to the next item.
4. Set the maximum speed of 18 . Press the Enter key to confirm and move to the next item.
5. Set the maximum incline value of 12, then press the Enter key to confirm. It will automatically enter into
the calibration display.
6. Press the START/STOP key to start the calibration. It will return to the standby screen automatically
after the calibration is complete.