Fuel CT 300, User Manual

Page: 49 / 60

49
TAG = Target H.R.C. - - Workout by your target heart rate value.
In “TAG” mode, use „UP/DOWN“-buttons for direct input of the target pulse value (default: 100). You may now
preset a target value for “TIME” by using “UP”, “DOWN” and “MODE/ENTER”. Press “START/ STOP” to start
workout. To pause your workout, press the „START/STOP “-button again. Press “RESET” to return to main menu.
Fig. 16 Fig. 17
WATT mode
With this mode you can exercise according to the preset Watt value. After selecting “W”, press “MODE/ ENTER” to
enter this mode. The default value for the WATT preset value is 120 (figure 18), which you may change with
“UP”/”DOWN” and “MODE/ENTER”. You may now preset a target value for “TIME” by using “UP”, “DOWN” and
“MODE/ENTER”. Press “START/STOP” to start workout. The computer will automatically control the resistance. You
may change the watt level at any time during exercise with “UP” and “DOWN”. To pause your workout, press the
„START/STOP “-button again. Press “RESET” to return to main menu.
Fig. 18
Recovery
With this special function, you can check your hearts recovery rate after a training session. This is a very important
indication for the physical condition of your body. Try to improve your recovery rate with regular training sessions.
The aim is, to calm down to a normal pulse frequency (frequency, when you are not in motion) as quickly as possible.
To check your recovery rate, you need to keep your hands onto the hand pulse-sensors (or keep wearing a chest
belt) after your exercise. Now press the button “RECOVERY”. The computer will start to countdown 60 seconds
(figure 19). During this period the computer will constantly measure your heart rate through the hand sensors. After
this minute, your recovery rate will be displayed on the display. The range is F1.0 to F6.0 (figure 20), whereby F1.0
is very good and F6.0 is insufficient. Improve your value by intense and regular training!
After the recovery function is finished, press “RECOVERY” again to return to normal operation mode.
Fig. 19 Fig. 20
Remarks:
1) This computer has an automatic on/off function so that it switches on when the pedals move or when
any button is pressed, and turns into stand-by mode automatically if no signal has been received for
approx. 4 minutes.
2) In case of any abnormal functions, disconnect the device from power source and reconnect after some
minutes.