4
STEP 2:
1.
Install Handle Bar (3) on Console Mast (2) and tighten the M8 × 30L Button Head
Socket Bolt (15) using the M5 Allen Wrench (33) to lock the handle bar in place.
Route the hand pulse sensor cable (65) through the console mounting plate as
shown below.
2.
Connect the console cable (37) and Hand Pulse Sensor Cable (65) to the Console
(38). Mount the console on the Console Mast (2) using the Phillips Head Screw
Driver (33) to tighten 4pcs of M5 × 12L Phillips Head Screws (31).
3.
Use 15m/m Wrench (64) to install both Pedals (11 left and right) on the crank axle.
The left pedal is a reverse thread and will screw in a counterclockwise direction.
The pedals are marked with an R or L on the end of the threaded pedal axle. Make
sure to tighten the pedals firmly or a clicking noise can occur during pedaling. It
may be necessary to retighten the pedals after use if clicking occurs.
4.
Install seat (16) on the triangular plate at the top of seat tube (6) by using
13/15m/m Wrench (64) to tighten 3 washers and 3 nyloc nuts that come attached
to the seat.
