Low Control:
Adjust the Low control to taste, it adjusts the low frequency spectrum of your amplifier.
800 Master:
The 800-Master sets the volume for the 800 channel. This control pulls out to switch to
the 900 channel manually. The footswitch is disengaged when the control is pulled.
900-Master:
The 900-Master controls the volume of the amp in channel-2 (high gain) mode. The input
gain sets the amount of distortion, and the master sets the volume at which this channel
operates.
Thrust Control:
The thrust control works on the power amp section on the low end and raises low end
gain and provides a bass boost and a looser overall feel and affects both channels.
Accent Control:
The accent control adds highs to the power amp section, altering the overall bite of the amp and
presence of the power stage on both channels.
5.
REAR PANEL CONTROLS, INPUTS/OUTPUTS
AC power cord input:
Using a standard IEC power cord. Connect to AC POWER IN on the amplifier and to AC
power source. Please note the voltage on the chassis, and make sure you are supplying
the correct AC voltage to the unit. Damage from incorrect voltages is not covered by
warranty.
AC power Fuse:
This fuse protects the amplifier if any malfunction occurs. Use ONLY the stock fuse
rating as supplied by factory and shown on the rear panel for the voltage and current in
your location.
Speaker outputs:
4, 8, 16-ohm outputs. Use the same impedance as the speaker you are using for
maximum power and performance and use
only one speaker output at a time
.
