OD-Gain:
The OD-gain control sets the amount of drive in the gain channel. This channel is
accessed by the left footswitch button, or by pulling the Overdrive Master control knob
out. This control will adjust how much gain and distortion you will have in channel-2.
OD-Master:
The OD-Master controls the volume of the amp in channel-2 (overdrive) mode. The
Overdrive gain (above) sets the amount of distortion, and the Overdrive master sets the
volume at which the drive channel operates.
OD-tone:
The OD tone control is a simple high cut control which allows you to go from “woman
tone” (full counter clockwise), to D-style (center 30% range), to rock/English tones (full
clockwise).
Reverb Level:
The Reverb level control adjusts the amount of reverb return to the amp.
Reverb Decay:
The Reverb decay adjusts the time it takes for the reverb signal to decay.
Counterclockwise is the shortest decay, and turning all the way clockwise increases the
decay time.
5.
REAR PANEL CONTROLS, INPUTS/OUTPUTS
AC power cord input:
Using a standard IEC power cord. Connect to AC POWER IN on the amplifier and to AC
power source. Please note the voltage on the chassis, and make sure you are supplying
the correct AC voltage to the unit. Damage from incorrect voltages is not covered by
warranty.
AC power Fuse:
This fuse protects the amplifier if any malfunction occurs. Use ONLY the stock fuse
rating as supplied by factory and shown on the rear panel for the voltage and current in
your location.
Speaker outputs:
4, 8, 16-ohm outputs. Use the same impedance as the speaker you are using for
maximum power and performance and use
only one speaker output at a time
.