www.fubag.ru
O
m
perator's
anual
- -
3
3. Preparing to charge
-
- I
-
-
-
-
-
Determine voltage of battery by referring to car owner s manual.
f it is necessary to remove battery from vehicle to charge, or to clean terminals, always remove
grounded terminal from battery first. Make sure all accessories in the vehicle are off, so as not to
cause an arc.
Clean battery terminals. Be careful to keep corrosion from coming in contact with eyes.
Add distilled water in each cell until battery acid reaches level specified by battery manufacturer.
This helps purge excessive gas from cells. Do not overfill. For a battery without cell caps, carefully
follow manufacturers recharging instructions.
Study all battery manufacturers specific precautions such as removing or not removing cell caps
while charging and recommended rates of charge.
Be sure area around battery is well ventilated while battery is being charged. Gas can be force fully
blown away by using a piece of cardboard or other nonmetallic material such as a fan.
Make sure the initial charging rate is not over battery manufacturers suggestion.
- This charger can easily be configured to charge many different types of 12V lead-acid batteries;
wet batteries, MF, AGM and most GEL-batteries.
The following recommendations should, however, only be seen as guidelines. When in doubt,
always consult the battery manufacturer for further instructions.
4. Description
MICRO
4 /12
0
Charger
POWER
FULL
CHARGING
DC12 V 2 A
For Lead Acid & Gel Cell Batteries
1
2
3
1.
.
. Battery repairing.
. Battery is during charging.
Light ON
2
3
