O
m
perator's
anual
www.fubag.ru
- 3 -
The manufacturer reserves himself the right to make the manual's content or
function
change without any preliminary notification of the users.
tools
4. Connection and operation
It is necessary to re-activate the tool before the operation start. To re-activate the tool pour the pure
paraffin through the inlet connecting pipe when the trigger is open, then blow the tool through with
the dry compressed air. Repeat it 2 or 3 times.
The system of the compressed air lead-in to the tool is in the below diagram.
Before the first putting the tool into operation it is necessary to pour in 5-10 ml of the machine oil as
per specification SAE#10 or its analog through the connecting pipe of the compressed air lead-in.
Blow the air hose through. Connect it to the tool, press the starting lever and operate the tool at no
load running within 2-3 minutes. After it release the starting lever.
If the lubricator is not used during the operation it is necessary to pour 5-10 ml of the machine oil as
per specification SAE#10 or its analogue into the inlet connecting pipe of the tool every operating
hour.
Use only the recommended lubricators
Check the thread connection tightening firmness on the housing of the tool periodically during the
maintenance their slackening is not allowed.
Avoid mechanical damages of the tool as it may cause malfunctions or failure.
Keep the tool clean to provide its proper operation.
Use the tool according to its intended purpose.
-
-
–
-
-
-
-
-
Specifications
Grinder
Clamping sleeve size, mm
6
No load spindle rotation speed, rpm
22000
Inlet diameter, inch
Operating pressure air consumption, l/min
142
Operating pressure, bar
6,3
Weight, kg
0,57
Air conductive hose diameter recommended, mm
6х8
Specifications
Hammer
Hammer bar length, mm
10,2
Bar type
round
Hammer length, mm
120
No load rapid blow, BPM
4500
Inlet diameter, inch
Operating pressure air consumption, l/min
121
Operating pressure, bar
6,3
Weight, kg
1,05
Air conductive hose diameter recommended, mm
6х8
