34
Cooling:
Press the Mode button until the function light ‘
Cool’ comes on, press the + and – buttons to set the
desired room temperature (17°C – 30°C). Using the FAN
SPEED button on the remote control, you can set the fan
speed to HIGH or to LOW.
Fanning:
Press on the Mode button until the ‘Fan” function
light comes on. Using the FAN SPEED button on the
remote control, you can set the fan speed to HIGH or to
LOW. The temperature cannot be set.
Speed
This allows you to set the desired speed. Press the button
to select low or high speed. This function isn’t available in
sleep mode and dehumidify mode.
The LED display shows the set temperature of the
cooling function. The room temperature is shown at
the dehumidifying and fanning functions. The LED
display also shows the following error and safety codes.
Error
codes:
E2
Temperature
sensor
error
E3
Condenser temperature sensor error
E4
Water reservoir is full
Water reservoir is full: Connect the drain hose to
the bottom water drainage point and let the
collected water run off (also see the section on
water drainage). If this safety code recurs, contact
your
supplier.
Remark: When one of the aforementioned faults occurs,
switch off the airco and check for possible obstacles. Restart
the airco. If the fault persists, switch off the airco and take
the plug out of the socket. Contact your supplier.
