FTX BANZAI, Set-Up Instructions And Parts Listing

Page: 8 / 20

8
Getting Started
Switch on transmitter.
Hold vehicle clear of the ground, connect battery pack and switch on receiver.
Bind the Transmitter and receiver if required.
Test the transmitter to check control of the vehicle with wheels off the ground.
Start driving slowly and if the vehicle does not go straight, adjust steering trim dial on Transmitter.
For the very first run use the throttle gently, to gradually bed in the motor brushes and help the driver become accustomed to the vehicles behaviour and
controls.
PLEASE NOTE:
Although the electronics are waterproof the rest of car can be subjected to damage if running in excessively wet or submerged conditions.
After Run.
Switch off the receiver power, switch off the transmitter and lower the aerial. Disconnect the battery and remove it from the vehicle, allow it to cool before
recharging. If you have a second charged battery all ready to use, still allow the vehicle to cool slightly before continuing.
Regular maintenance.
Frequently check the whole vehicle for loose or missing fixings. Use thread lock on any replacement screws
into metal threads.
Frequently check rotating parts are free from grass, string etc. that might bind their motion and over stress the
motor or speed controller. Remove the wheels occasionally and check behind the mounting hex for obstructions
or anything that might have been wrapped around the axle and caused extra drag.
Check the gear mesh frequently and remove any stones or grit from gear teeth to prevent premature wear and
damage.
If the motor moves, or is removed for maintenance/exchange, the gear mesh will need to be set. Simply slacken
the motor retaining screws and adjust the motor until there is just discernable backlash between pinion and
spur teeth. If the gear is too tight or too loose the gears will be noisy and could be damaged.
Shock absorbers will wear prematurely if used in dirty dusty conditions. Replace oil and seals as required to keep a smooth dampening action.
Trouble shooting guide.
Warranty
Due to the nature of this product and potential use FTX warrants it to be free of material and workmanship defects when new. FTX will at its sole discretion
repair or replace defective components free of charge within 30 days from date of purchase. This warranty does not cover wear and tear, crash or impact
damage, modifications, component water damage failure to perform maintenance or damage from improper use. Proof of purchase date will be required to
action any warranty claims.
Instructions for disposal.
This product must not be disposed of with other waste. Instead, it is the user’s responsibility to dispose of their waste equipment by handing it over to a
designated collections point for the recycling of waste electrical and electronic equipment.
For more information about where you can drop off your waste equipment for recycling, please contact your local council, your household waste disposal
service or where you purchased the product.
Short Runtime:
Battery damaged/not
charged
Motor dirty or brushes worn
Drivetrain binding
Sluggish Action:
Motor dirty or brushes worn
Bind in drive train
Battery running low on
power
Motor/ESC overheat:
Over-geared
Binding transmission.
Seized axle bearing.
Motor binding
Motor spins but vehicle
refuses to move:
Gears damaged.
Gears loose on shaft.
Slipper clutch too loose.
Drive shaft broken or
missing.
Poor Range or fails to
operate:
Transmitter batteries low
Vehicle Battery Low.
Transmitter switched off
Transmitter/receiver aerial
not extended.
ESC switched off or battery
not connected.
Loose connectors/wires.
Water damage. Model
electronics are not
waterproof.
FTX Banzai-Manual_Banzai 11/12/2013 16:12 Page 8